Rotary attachment help

A place for users to ask questions and search for already asked questions. "BE NICE" and helpful!

PM GeneMpls with Questions about this FAQ PM - Top Right Side by your name.
John Lifer
Posts: 116
Joined: Mon Dec 05, 2016 7:02 am
Location: NorthWest Arkansas

Re: Rotary attachment help

Post by John Lifer » Fri Jan 06, 2017 9:53 pm

This is how my machine was set up from factory. Connector on side, three position toggle, yaxis off and rotary. I do power down also.

I do use the enable rotary and change the diameter and also the steps. My machine should be running 7500 steps according to switches on y axis controller and then teeth multiplier, but that doesn't work. I change both settings to make it rotate correctly. But I don't want to go into setting and us pw to change settings. Too dangerous in my opinion.
Working with a Ray Fine Chinese CO2 Laser
RF-13900 1300x900 bed, 80 Watt
Using TR and RDworks V8.01.19
Other equipment 20watt RF fiber laser
John in NWA

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest