Good discussion on pluses and minuses of cast vs. extruded acrylic

Discussion on what materials you laser cut or engrave
Doug Fisher
Posts: 360
Joined: Sat Aug 20, 2016 10:42 am
Location: Atlanta, Georgia, USA

Good discussion on pluses and minuses of cast vs. extruded acrylic

Postby Doug Fisher » Fri Dec 16, 2016 10:10 pm

Sorry if these is a repeat. I know I picked this up from a post I found somewhere on the net but I couldn't find it here on this forum and it is really good for newbies to read. Thanks to the original poster, wherever I saw it!

http://www.pmma.dk/Acryl_stobt_kontra_e ... Lang=en-GB
80 Watt 700mm x 500mm Ke Hui KH-7050 Laser (Similar to the Red Sail),T.R.
LaSea/EFR F2 Series laser tube, RuiDa RDC6442G EC controller, 2" lens, RDWorks v8.01.18, CW 5000 chiller, Chuck type of rotary attachment
Doug

Return to “Materials to Laser”

Who is online

Users browsing this forum: No registered users and 1 guest